Iranian Journal of Materials Science and Engineering

---

In this study, Ta powder was produced from Ta scarp via chemical processes using Mg and Ca powders. At first, Tantalum scraps were converted to Tantalum oxide (Ta₂O₅) at 1100˚C in an oxygen atmosphere. Tantalum oxide was reduced to Tantalum powder with Mg in a vacuum environment at 950 to 1200˚C for 3 hours. The obtained Ta powders further were reacted with Ca at 950˚C for 5 hours in a vacuum atmosphere. The powders were analyzed through X-ray diffraction patterns (XRD), scanning electron microscopy (SEM), as well as oxygen measurement. The results show that the average particles size of the produced Ta powders is about 58 nm with oxygen contents of 250 ppm.

---

This contribution evaluates the influence of Cr doping on the ground state properties of SrTiO3 Perovskite using GGA-PBE approximation. Results of the simulated model infer agreement with the previously published literature. The modification of electronic structure and optical properties due to Cr3+ doping levels in SrTiO3 has been investigated. Structural parameters infer that Cr3+ doping alters the electronic structures of SrTiO3 by shifting the conduction band through lower energies for the Sr and Ti sites. Substituting Ti site by Cr3+ results the energy gap in being eliminated revealing a new electrical case of conducting material for the system. Furthermore, it has been noticed that Cr doping either at Sr or Ti positions could effectively develop the SrTiO3 dielectric constant properties. Consequently, Cr3+ is an effective dopant due to enhancing the optical absorption properties, thus opening up new prospects for optoelectronic applications.

---

The copper oxide nanoparticles were synthesized using a precipitation method, recognized for its significance in antibacterial applications. This study reports the synthesis of pure CuO and CuO:Cd nanoparticles at two different concentrations, and explores their structural properties and antibacterial activity. The structural characteristics of the prepared powders were analyzed using X-ray diffraction (XRD), scanning electron microscopy (SEM), and energy-dispersive spectroscopy (EDS). Raman spectra were also examined using a 543 nm laser wavelength. XRD analysis confirmed that the as-synthesized samples exhibit a face-centered monoclinic structure, with crystallite size decreasing as dopant concentration increases, as estimated using the Scherrer method. The obtained crystallite sizes ranged from 7.13 to 11.72 nm, likely due to the larger atomic radius of Cd compared to Cu. The major Raman lines observed included Au2 (156 cm^-1), Ag (∼294 cm^-1), Bu2 (∼598 cm^-1), and lines at 1100 cm^-1 and 1420 cm^-1. The antibacterial activity of the synthesized CuO and CuO:Cd specimens was evaluated using the Kirby-Bauer disk diffusion method against Gram-positive Staphylococcus aureus and Gram-negative Escherichia coli bacteria. The antibacterial activity increased with higher Cd concentrations and smaller particle sizes, resulting in larger inhibition zones and higher percentage inhibition ratios for both types of bacteria.
The copper oxide nanoparticles were synthesized using a precipitation method, recognized for its significance in antibacterial applications. This study reports the synthesis of pure CuO and CuO:Cd nanoparticles at two different concentrations, and explores their structural properties and antibacterial activity. The structural characteristics of the prepared powders were analyzed using X-ray diffraction (XRD), scanning electron microscopy (SEM), and energy-dispersive spectroscopy (EDS). Raman spectra were also examined using a 543 nm laser wavelength. XRD analysis confirmed that the as-synthesized samples exhibit a face-centered monoclinic structure, with crystallite size decreasing as dopant concentration increases, as estimated using the Scherrer method. The obtained crystallite sizes ranged from 7.13 to 11.72 nm, likely due to the larger atomic radius of Cd compared to Cu. The major Raman lines observed included Au2 (156 cm^-1), Ag (∼294 cm^-1), Bu2 (∼598 cm^-1), and lines at 1100 cm^-1 and 1420 cm^-1. The antibacterial activity of the synthesized CuO and CuO:Cd specimens was evaluated using the Kirby-Bauer disk diffusion method against Gram-positive Staphylococcus aureus and Gram-negative Escherichia coli bacteria. The antibacterial activity increased with higher Cd concentrations and smaller particle sizes, resulting in larger inhibition zones and higher percentage inhibition ratios for both types of bacteria.
 

---

This work reports the influence of Cu dopant and annealing temperature on CdO_x thin films deposited on glass substrates by spray-pyrolysis method. The Cu doping concentrations were 0, 0.46, and 1.51 at% with respect to the CdO_x undoped material. Then, the fabricated films were subjected to annealing process at temperature of 450°C. X-ray diffraction (XRD) examination confirms that the as-deposited films show a cubic crystallographic structure with high purity of CdO in the annealed films. It was found that the (111) peak is the most predominant diffraction orientation in the surveyed samples. At the microscopic scale, AFM machine was operated to quantify the three important parameters of the mean roughness (Ra), rms value (Rq), and z scale. These parameters hold highest values for the sample with 0.46 at% of Cu. Finally, reflectance, absorbance, transmittance and other optical parameters dielectric measurements were comprehensively analyzed. Our evaluation of optical band gaps for the studied samples reveals that the synthesized films have direct band gap character with the fact that the rise in the Cu contents in the as-deposited films lead to lessen the band gap values. In contrast, annealing process results in raising the band gap.